ASTM D4501 TESTING FIXTURE

 

ASTM D4501 Testing Fixture – Application
ASTM D4501 Testing Fixture – Application

This test method describes a procedure and fixture used to determine shear strengths of adhesives used to bond materials with moduli higher than the modulus of the adhesive. The size and shape of the specimens are variable within the physical restraints of the fixture.

Two blocks of specific sizes are bonded together. A typical test specimen consists of a 1” x 1” block, typically up to ½” thick, bonded in the center of a 3” x 3” block, also typically up to ½” thick. The block thicknesses are not critical. To maintain the largest block in position in the main body, against the front plate, is used the toggle clamp. The smaller block is positioned in the opening in the guillotine bar, which is temporarly held in the proper position for specimen insertion by the thumb screw shown in the front face plate.

Before the test is started, this thumb screw is loosened. The fixture is gripped at bottom and  top in standard tensile grips in the testing machine.

Additional Information

Test Standard ASTM D4501
Maximum Load 45 kN
Temperature Range  -80 °C to 130 °C
Specimen Thickness depending on material
Mass 10 Kg

References:

  • ASTM Standard D 4501-01 (2001), “Standard Test Method for Shear Strength of Adhesive Bonds Between Rigid Substrates by the Block-Shear Method, American Society for Testing and Materials, West Conshohocken, Pennsylvania (first published in 1985).