SPECIMEN TABBING FIXTURES

There are four strips of tabbing material to maintain in proper alignment. A typical fixture consists of two plates, aligned with each other via pins in the base plate that slip into close-fitting mating holes in the cover plate. Usually the plates are manufactured of high-strength, anodized aluminum, although in …

Read more

RESIN CASTING MOLDS TESTING FIXTURE

To characterize the mechanical properties of the polymer to be used as the matrix material in a new composite material system it is often necessary. Thermoset polymer specimens can often be cast to finish dimensions in open molds.

BS EN 455-2 – PUNCH TESTING FIXTURE

BS EN 455-2 describes the testing requirements for determination of physical properties, including break strength, before and after accelerated aging, of medical gloves for single use, surgical gloves, examination/procedure gloves, long-cuff medical gloves, and seemed/welded gloves. For this test, we recommend either pneumatic grips side acting grips or mechanical elastomeric …

Read more

ASTM D638 A TESTING FIXTURE

The fixture was designed in relation to the test method expressed in ASTM D638 designation. This method has been realized to produce tensile properties data for the control and specification of the plastic materials. The collection of these data is useful for the qualitative characterization and for research and development. This …

Read more

ASTM D638 B TESTING FIXTURE

ASTM D638  tensile tests measure the force required to break a plastic sample specimen and the extent to which the specimen stretches or elongates to that breaking point. Tensile test procedure: Specimens are placed in the grips of the universal tester at a specified grip separation and pulled until failure. …

Read more