Tensile Loading

TENSILE WEDGE GRIP INSERTS

TENSILE WEDGE GRIP INSERTS Wedge grip inserts of all types, in all sizes and load capacities to fit all existing wedge grip bodies, can be provided, including custom designs for special applications. While machined serration grip faces, either straight- or cross-serrated, are very popular, grip faces covered with tungsten carbide ...

Read more

ADAPTERS, LOCKS RINGS AND PINS

ADAPTERS, LOCKS RINGS AND PINS Locking rings, adapters, and brooches of any configuration, to adapt specific test equipment to every type of mechanical or servo-hydraulic test machine. Every sistem can be customized according to Customer needs.

ASTM D897 Testing Fixture

ASTM D897 Testing Fixture To help maintain the axial alignment load, usually universal joints are used in traction load applications. Can be designed and manufactured universal joints of all the final attack configurations and the load capacity. Usually, the material chosen for the realization of joints is 17-4 PH stainless ...

Read more

STANDARD TENSILE WEDGE GRIPS

  STANDARD TENSILE WEDGE GRIPS - sizes Sophia High Tech provides a wide range of tensile wedge grips to perform your testing. Elevated and reduced temperature tensile test procedures are available. Tensile tests measure the force required to break a plastic sample specimen and the extent to which the specimen stretches or elongates ...

Read more

ASTM D882 TESTING FIXTURE

ASTM D882 TESTING FIXTURE In general, the thin sheet to be tested, plastic or metal film or sheeting up to 0.040 "in thickness, is held by the line of contact at each end between the flat reinforcing plates and the eccentric rolls. To facilitate the installation of the specimen cylinders ...

Read more

ASTM C307 TESTING FIXTURE

ASTM C307 TESTING FIXTURE The equipment is composed of lower and upper handles, which are equal. Its purpose is to determine the resistance to traction of briquettes special form of mortar, mortar and other similar materials of monolithic lining. The stop plates on the grips center the specimen fore and ...

Read more

ASTM D897 TESTING FIXTURE

This test method covers the comparative tensile properties  determination of the adhesive bonds of metal to metal when tested on standard shape specimens and under defined conditions of pretreatment, temperature, and testing machine speed. The grips are to be threaded directly into self-aligning male-thread fittings in the base and crosshead ...

Read more

ASTM D1623 TESTING FIXTURE

Foam tests and foam testers provide a standard method of obtaining data for research and development, quality control, acceptance or rejection under specifications, and special purposes. Type A specimens are used when enough sample material exists to form the necessary specimen. Type B is preferred when smaller specimens are available, ...

Read more

SPLIT CAPSTAN GRIPS

SPLIT CAPSTAN GRIPS To tensile test cordage,  rope, flat strapping and similar flexible materials that might be otherwise difficult to grip without creating undesirable stress concentrations and premature failures, typically are used split capstan grips. Depending on your needs, it is possible to configure the capstan grips. To hold the ...

Read more

ASTM D412 TESTING FIXTURE

ASTM D412 Testing Fixture This method covers the effect of the application of a tension load to vulcanized rubber and similar rubber-like material at room temperature and elevate temperature. Covered are tests for tensile stress, tensile strength, ultimate elongation and set. The method is not applicable to the testing of ...

Read more